–
| Apply only a very thin coat of grease -G 052 168 A1- when lubricating the seal -arrow- in the cover. |
–
| Install cover with new seal. |
Remaining installation steps are carried out in reverse sequence. |
–
| Install and adjust thrust piece at steering pinion end → Chapter. |
Perform a basic setting for the steering angle sender -G85- using vehicle diagnostic, testing and information system -VAS 5051B- after installing. |
–
| Perform adaption and basic setting for steering moment sender -G269- using vehicle diagnostic, testing and information system -VAS 5051B-. |
|
|
|