A3 Quattro L4-2.0L Turbo (CBFA) (2009)
/Page-573002.png)
-
Remove the coolant pump from the centering pin and remove the engine oil cooler.
‹› Ignore - arrow -.
Installing
‹› Tightening specifications. Refer to => [ Coolant Pump and Thermostat Assembly Overview ] See: Coolant Pump and Thermostat Assembly
Overview.
Installation is in the reverse order of removal, note the following:
‹› Replace seals and O-rings.
-
Coat the O-rings - 4 - with coolant; coolant. Refer to.
-
Make sure both centering pins are installed in the cylinder block.
-
Install the connection piece - 2 - into the engine oil cooler - 1 -.
-
Push the coolant pump - 3 - onto the connection piece and onto the centering pins in the cylinder block.
-
Tighten bolts - 1 to 5 -.
