A3 Quattro L4-2.0L Turbo (CBFA) (2009)
‹› The notch on the vibration damper must line up with the arrow marking on the timing chain lower cover.
-
Remove vibration damper bolt using Counterhold ( T10355).
CAUTION!
The engine could be destroyed.
‹› In order not to change the valve timing, the crankshaft must not be moved out of the "OT" position when the vibration damper is
removed.
Installing
‹› Tightening specifications. Refer to => [ Ribbed Belt Drive Assembly Overview ] See: Drive Belts, Mounts, Brackets and Accessories/Drive
Belt/Service and Repair/Ribbed Belt Drive Assembly Overview.
Installation is in reverse order of removal, note the following:
‹› Replace the vibration damper bolt.
‹› Replace O-ring - 1 -.
-
Coat the sealing lip with transmission oil.
-
Mount the vibration damper; when doing this, pay attention to the tooth contour - arrow -.
-
Install ribbed belt. Refer to => [ Ribbed Belt ] See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Ribbed Belt.