A3 Quattro L4-2.0L Turbo (CBFA) (2009)
/Page-1639003.png)
Seats.
-
Remove sill panel trim. Refer to => [ Sill Panel Trim ] See: Body and Frame/Interior Moulding / Trim/Service and Repair/Removal and
Replacement/Trim.
-
Remove luggage compartment floor covering.
-
Remove 1/3 rear seat backrest. Refer to => [ Left 1/3 and Right 2/3 Backrest without Center Armrest Component Overview ] See: Body and
Frame/Seats/Service and Repair/Removal and Replacement/Rear Seats.
-
Remove 2/3 rear seat backrest. Refer to => [ Left 1/3 or Right 2/3 Backrest ] See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seats.
-
Disengage strap at rear lid bracket and remove rear shelf back out of mounts on luggage compartment side trim.
-
Remove rear cross panel trim: vehicles with front wheel drive. Refer to => [ Rear Cross Panel Trim Component Overview, FWD ] See: Body and
Frame/Interior Moulding / Trim/Service and Repair/Removal and Replacement/Trim, vehicles with all wheel drive => [ Rear Cross Panel Trim
Component Overview, AWD ] See: Body and Frame/Interior Moulding / Trim/Service and Repair/Removal and Replacement/Trim.
-
Remove luggage compartment side trim. Refer to => [ Luggage Compartment Side Trim ] See: Body and Frame/Interior Moulding / Trim/Service
and Repair/Removal and Replacement/Trim.
-
Remove rear outer floor assembly anchorage point. Refer to => [ Outer Rear Floor Assembly Anchorage Point ].
-
Remove the bolt - 2 -.
-
Disengage belt roller - 4 -.
-
Remove rear three-point seatbelt.
Installing
Installation is reverse of removal, but note the following:
-
Make sure the belt roller - 4 - fits correctly into the cut-out in the side panel bracket - 7 -.
-
Be careful to install the belt webbing - 3 - without twisting it.
-
If the belt roller was removed as the result of an accident, replace bolt - 2 -.
-
Ensure three-point seat belt is not obstructed by wires, insulation, etc.
5
Cover
‹› for belt roller without belt tensioner
6
Cover
‹› for belt roller/belt tensioner
7
Side Panel with Console
8
Belt Tensioner Connector
‹› Disconnecting and connecting. Refer to => [ Connector and connector lock, disconnecting from or connecting to belt roller/belt tensioner ].
9
Rear Side Trim
10
Belt Guide
‹› Removing and Installing. Refer to => [ Belt Guide ]
11
Belt
‹› for belt roller/belt tensioner
