A3 Quattro L4-2.0L Turbo (CBFA) (2009)
Shifter A/T: Removal and Replacement
Cover Circuit Board with Selector Lever Scale Illumination
Cover Circuit Board with Selector Lever Scale Illumination
Removing
-
Remove cover for shift mechanism => [ Selector Lever Boot, Separating from Selector Lever Handle ] See: Selector Lever With Boot/Selector
Lever Boot, Separating From Selector Lever Handle.
-
Press down retaining hooks - arrows - and pull off cover - 2 - from guide - 1 -.
-
Remove circuit board for the cover.
Installing
Install in reverse sequence; note the following points:
‹› When assembling the cover, make sure that the retaining tabs of the guide do not break off.
-
Install cover for shift mechanism => [ Selector Lever Boot, Separating from Selector Lever Handle ] See: Selector Lever With Boot/Selector
Lever Boot, Separating From Selector Lever Handle.