A3 Quattro L4-2.0L Turbo (CBFA) (2009)
/Page-853006.png)
-
Apply sealant - hatched surface - to clean surface on inner side of protective joint boot cap. Sealant bead: unbroken, 2 to 3 mm. Skirt area around
inner holes - arrow -.
-
Use sealant D 454 300 A2 for this
-
Slide joint protective boot onto driveshaft.
‹› Drive shaft, protective joint boot and cap contact surfaces must be free of grease.
‹› Make sure to not damage the sealant bead.
-
Using screws - arrows -, align protective boot and cap with screw holes.
