A3 Quattro L4-2.0L Turbo (CBFA) (2009)
The CV boot is frequently pressed in when placed on the CV joint body. This creates a vacuum in the CV boot, which pulls a fold inward when the car
is driven - arrow -.
Therefore, observe the following:
-
Before clamping sleeves, balance pressure by raising protective joint boot.
Tensioning Stainless Steel Clamps for Hytrel Protective Joint Boots
-
Position CV joint boot clamp tool (VAG1682) as shown in illustration. Be sure that edges of clamping pliers are seated in corners - arrows B - of
hose clamp.
-
Tighten hose clamp by turning spindle - A - using a torque wrench (do not tilt clamping pliers).
‹› Tightening Specifications: 20 Nm