A3 Quattro V6-3.2L (BUB) (2008)
7
-
Latch cover
-
When assembling, cover must engage audibly into lid lock.
8
-
Hinge arm
-
To remove, pivot operating rod - 2 - 90 degree and disengage operating rod.
9
-
Release element
-
Inserted sideways on lock lever.
Lid Lock, Removing
-
Rear lid trim removed.
-
Operating rod to actuator removed.
-
Remove hex nuts - 3 - and remove lid lock - 2 - from lid - 1 -.
-
When installing, tighten nuts to 21 Nm.
Actuator, Removing
-
Disconnect electrical connectors.
-
Operating rod - 2 - disengaged at lid lock.
-
Loosen bolts - 5 - and slide actuator - 1 - with mounting plate - 3 - out of elongated holes in rear lid.
-
Remove actuator with mounting plate - 3 - from lid.
-
Remove screws - 4 - and remove actuator.
-
To remove, pivot operating rod - 2 - 90 degree out of clip in opposite - direction of arrow -.