A3 Quattro V6-3.2L (BUB) (2008)
/Page-760005.png)
disconnect harness connector.
-
Attach Puller For Ignition Coil (T10095 A ) on ignition coils - arrow - as depicted in the illustration and pull out ignition coils in succession.
-
Remove ignition wiring harness strip and set it aside.
‹› Depending on the construction version, low pressure connectors were used in the version shown. To disconnect, slide back rubber cap - 1 - and
slide release button - 2 - to the rear.
-
Disconnect vacuum hoses - 2 through 5 - at rear of the intake manifold.
