audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Heater Control Module, Checking|Page 7641 > < Heater Control Module, Checking|Page 7639
Page 1
background image

Control Module HVAC: Testing and Inspection
Engine Control Module, Activating

Engine Control Module, Activating

Special tools, testers and auxiliary items required

‹› Test Box 105 Pin (V.A.G 1598/42-1) and Test Adapter (V.A.G 1598/47)

‹› Vehicle Diagnostic, Testing and Information System ( VAS 5051 A) with Multimeter Leads (VAS 5051/7 )

‹› These functions are dependent on the version of the engine and of the engine control module and are not present on all vehicles Vehicle Diagnosis,

Testing and Information System VAS 5051 under "Guided Fault Finding" for the respective ECM) Wring diagrams, Troubleshooting &
Component location. 

‹› On vehicles with a manual climate control system, the A/C Control Module (J301) exchanges the information via the databus system with each 

engine control module Vehicle Diagnosis, Testing and Information System VAS 5051 under "Guided Fault Finding.

‹› The Heater Control Module (J65) has a potentiometer installed. This potentiometer is operated via rotary switch for temperature preselect - A -

and therefore transmits position of rotary temperature switch to engine control module.

-

On vehicles with diagram-mapped cooling, activation of Map Controlled Engine Cooling Thermostat (F265) is influenced by the respective
Engine Control Module (ECM) on certain engines. If rotary switch for temperature preselect - A - is located at " Warm" stop or closely in front of
it, coolant temperature is reduced (limited to approximately 95 °C) to prevent excessive air blower temperatures from heater air vents Vehicle
Diagnosis, Testing and Information System VAS 5051 under "Guided Fault Finding (for respective Engine Control Module -ECM-). (for the
respective engine control module).

-

In vehicles with gasoline direct fuel injection engine "FSI ", mixture formation is influenced by respective Engine Control Module (ECM) on
certain engines. If rotary switch for temperature preselect -  A - in area of "Warm" stop or closely in front of it, improved coolant heating (and thus

Heater Control Module, Checking|Page 7641 > < Heater Control Module, Checking|Page 7639