A3 Quattro V6-3.2L (BUB) (2008)
-
Remove nut - 1 -.
-
Pull central tube - 2 - with cable guide as far from bulkhead as possible.
-
Remove bolts - 2 - (qty. 7).
NOTE: To provide a better overview, the cable guide, wiring harness, heating and A/C unit and surrounding area were not shown in the
illustration.
-
Remove central tube - 1 - upward diagonally.
NOTE: When removing central tube, pay attention to the left and right tunnel support. Avoid damage to the rear channel.
Installing
Installation is reverse of removal, but note the following:
-
When installing central tube, pay attention to bulkhead/central tube brace marking.
-
When connecting electrical connectors, ensure they engage correctly (audibly).
-
Install instrument panel.
-
Install center console.
-
Install steering column switch module.
-
Install steering column switch module trim.
-
Adjust wiper arms.
Tightening torques
Component.........................................................................................................................................................................................................................Nm