A3 Quattro V6-3.2L (BUB) (2008)
Fuel Gauge Sender: Service and Repair
Fuel Level Sensor
Fuel Level Sensor
Removing
Observe safety precautions => [ Safety Precautions ] See: Powertrain Management/Fuel Delivery and Air Induction/Service Precautions/Vehicle
Damage Warnings/Safety Precautions/Fuel Supply System.
Observe rules for cleanliness => [ Clean Working Conditions ] See: Powertrain Management/Fuel Delivery and Air Induction/Service
Precautions/Vehicle Damage Warnings/Clean Working Conditions/Fuel Supply System.
-
Remove fuel delivery unit => [ Fuel Delivery Unit ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pump/Service and
Repair/Fuel Delivery Unit.
-
Release retaining tabs - arrows - using a screwdriver and remove the fuel level sensor (G) upward and out.
CAUTION!
Before remove electrical connectors on Fuel Level Sensor (G), first release contact retaining tabs.
-
Disengage electrical connector retaining tabs - 1 to 3 - and disconnect them.
Installing
Installation is in reverse order of removal, note the following:
-
Insert fuel level sensor (G) into guides on the fuel delivery unit and push up until it engages.