A3 Quattro V6-3.2L (BUB) (2008)
/Page-658005.png)
Bolting at wheel bearing housing may occur only when dimension "a" has been obtained. Refer to => [ Rear Axle in Curb Weight Position ] See:
Steering and Suspension/Suspension/Service and Repair/Rear Axle in Curb Weight Position.
-
Tighten bolt for tie rod - 1 -.
-
Tighten lower transverse link bolt - 3 -.
-
Install bolt - 3 - with the washer - 4 - and tighten.
The washer - 4 - is installed on vehicles with an aluminum wheel bearing housing.
-
Tighten bolt - 1 - for upper transverse link.
