A3 Quattro V6-3.2L (BUB) (2008)
Parking Assist Control Module: Service and Repair
Park Assist, Through 05.2008
Park Assist, Through 05.2008
Parking Assist Control Module
Component location: in the back of the luggage compartment on the right side under the side trim.
Removing
-
If the control module was replaced, select the "Replace" function for the respective control module in "Guided Fault Finding" or "Guided
Functions".
-
Select the function or path:
-
Follow further instructions on display of VAS 5051B .
-
Switch off ignition and remove ignition key.
-
Remove luggage compartment right side trim.
-
If equipped, disconnect the connectors - 2 - and - 3 -.
-
Release clip - arrow - and pull Towing Recognition Control Module J345 - item 1 - out of mounting frame.
-
Disconnect electrical connectors - 2 - and - 3 -.
-
Release clip - arrow - and pull park assist control module J446 - item 1 - out of mounting frame.
Installing
Install in reverse order of removal, noting the following:
-
If the park assist control module J446 was replaced, then it must be re-coded .
-
Select the function or path: