A3 Quattro V6-3.2L (BUB) (2008)
Fuel Gauge Sender: Service and Repair
AWD Version 2
Fuel Level Sensor 2
Special tools, testers and auxiliary items required
‹› Wrench (T10202)
Removing
Observe safety precautions => [ Safety Precautions ] See: Powertrain Management/Fuel Delivery and Air Induction/Service Precautions/Vehicle
Damage Warnings/Safety Precautions/Fuel Supply System.
Observe rules for cleanliness => [ Clean Working Conditions ] See: Powertrain Management/Fuel Delivery and Air Induction/Service
Precautions/Vehicle Damage Warnings/Clean Working Conditions/Fuel Supply System.
‹› To remove Fuel Level Sensor 2 (G169), the fuel tank may only be filled to a maximum of 1/3. Empty fuel tank if necessary. Procedure => [ Fuel
Tank, Draining ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Procedures.
CAUTION!
Risk of destroying electrical components when battery is disconnected.
‹› Observe measures when disconnecting battery.
-
Disconnect battery.
-
Open fuel filler flap briefly and then close again.
-
Remove rear seat bench
-
Unclip retainers - arrows - of the cover for left sealing flange.
-
Disconnect electrical harness connector - 1 - at locking flange.