A3 Quattro V6-3.2L (BUB) (2008)
![background image](/audi/a3_quattro/v6-3.2l_(bub)/Page-2130001.png)
Steering Angle Sensor: Service and Repair
Steering Column Switch Module
Steering Column Switch Module
General Information
The steering column switch module consists of coil connector with slip ring, Steering Angle Sensor (G85), steering column switch (lever switches for
the windshield wiper, turn signal indicator/light switch, cruise control switch), Steering Column Electronic Systems Control Module (J527) and
ignition switch.
Check Steering Column Electronic Systems Control Module (J527).
Steering Angle Sensor
Removing
-
If the control module was replaced, select the "Replace" function for the respective control module in "Guided Fault Finding" or " Guided
Functions".
-
Select the function or path:
-
Follow further instructions on display of (VAS 5051B).
-
Remove return spring with slip ring => [ Airbag Spiral Spring/Return Spring With Slip Ring ].
-
Remove Steering Angle Sensor (G85) - arrow -.
Installing
Install in reverse order of removal, observing the following:
-
The steering angle sensor must be adapted in "Guided Fault Finding" or "Guided Functions" after replacing the airbag spiral spring/return spring
with slip ring.
-
Select the function or path: