audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Wheel Bearing Housing and Wheel Bearing Unit General Information|Page 7375 > < Wheel Bearing Housing and Wheel Bearing Unit General Information|Page 7373

A3 Quattro V6-3.2L (BUB) (2008)

Page 2
background image

Tightening of the respective bolts/nuts must then only occur after dimension - a -, which was measured before installation between the wheel hub
center and the lower edge of wheel housing, has been attained 

CAUTION.
‹› Do not lift or lower vehicle with engine/transmission jack below vehicle. 

‹› Do not leave engine/transmission jack (VAG 1383 A ) below vehicle any longer than necessary.

-

Tighten respective bolts/nuts.

-

Lower wheel bearing housing.

-

Move engine and transmission jack away from under vehicle.

-

Remove wheel hub support (T10149).

Wheel Bearing Housing and Wheel Bearing Unit General Information|Page 7375 > < Wheel Bearing Housing and Wheel Bearing Unit General Information|Page 7373