A3 Quattro V6-3.2L (BUB) (2008)
Windshield Washer Spray Nozzle: Adjustments
Windshield Washer Spray Nozzles, Adjusting, Through 05.2008
Windshield Washer Spray Nozzles, Adjusting, Through 05.2008
Special tools, testers and auxiliary items required
-
Windshield Washer Aiming Tool T10127 equipped with Replacement Tip 3125/5A
Adjusting
NOTE: The settings indicate the values for a moving vehicle, i.e. the spray from the jets is slightly offset when the vehicle is stationary.
-
Mark the four points on windshield using a water soluble marker:
-
Dimension - a - = 270 mm
-
Dimension - b - = 460 mm
-
Dimension - c - = 540 mm
-
Dimension - d - = 385 mm.
-
Aim the individual jets at the points using the setting tool T10127 .
-
If the spray field does not correspond to the specifications, clean dirty spray jet.
Cleaning the nozzle:
-
Remove nozzle .
-
Flush nozzle opposite to spray direction using clear water.
-
To remove remaining impurities, the nozzle must only be blown out opposite to spray direction using compressed air.
-
If the spray field still does not correspond to the specifications, replace the spray jet.