A3 Quattro V6-3.2L (CBRA) (2009)
/Page-1878001.png)
Rear Door Panel: Service and Repair
Window Regulator Switch
Window Regulator Switch
Removing
-
Switch off ignition and remove ignition key.
-
Remove door trim.
-
Remove insulation from door trim.
-
Disconnect the connector - 1 -.
-
Carefully release retaining hooks - arrows - with a small screwdriver.
-
Remove window regulator switch - 2 - downward out of switch mount.
Installing
Installation is reverse of removal, but note the following:
-
Press window regulator switch into switch mount until retaining hooks engage.
-
Install door trim. Refer to => [ Rear Door Trim ]. See: Rear Door Trim
