A3 Quattro V6-3.2L (CBRA) (2009)
Trunk / Liftgate Shock / Support: Service and Repair
Gas-Filled Strut for Rear Lid
Removing
-
Prop up and secure rear lid in open position.
-
Using screwdriver, lift retaining spring - 3 - as shown and remove gas-filled strut - 1 - from upper ball head pin - 2 -.
‹› After completely removing gas-filled strut, ensure correct position when installing.
‹› Noise insulation component must be installed on the body side.
Installing
Installation is reverse of removal, noting the following:
-
To install, press gas-filled strut onto ball head pins so that it engages in position.
-
Ball head pin tightening specification 20 Nm-1 Nm