Audi Workshop Service and Repair Manuals

-

Remove the bolt - 5 -.

-

Remove bolts - 6 - (Qty. 3) from below in area of glove compartment front edge.

-

Support glove compartment.

-

Remove bolts - 7 - (Qty. 2) from rear edge of glove compartment.

-

Disconnect glove compartment input wire/wiring harness connection -  2 -.

-

Remove glove compartment.

-

Remove glove compartment wiring harness if necessary.

-

Remove glove compartment cover brake. Refer to=> [ Glove Compartment Cover Brake ] See: Glove Compartment Cover Brake.

-

Remove footwell light. 

-

Remove glove compartment lamp. 

Installing

Installation is reverse of removal, but note the following:

-

Make sure the connectors engage completely (audibly).

-

Secure glove compartment wiring harness in clips designed for this. Refer to => [ Glove Compartment Wiring Harness Routing and Securing ] 
See: .

-

Note tightening sequence when tightening bolts. Refer to => [ Glove Compartment, Installing ].

2

Supply Wire/Wiring Harness Connector

‹› Glove compartment wiring harness, routing and securing, refer to=> [ Glove Compartment Wiring Harness Routing and Securing ] See: 

3

Instrument Panel

4

Right Instrument Panel Cover

‹› Removing and Installing, refer to => [ Left and Right Instrument Panel Cover ] See: Dashboard / Instrument Panel/Service and

Repair/Instrument Panel

5

Bolt 

3.5 Nm

‹› Tightening sequence, refer to => [ Glove Compartment, Installing ] See: 

6

Screws

3.5 Nm

‹› Qty. 3

‹› Tightening sequence, refer to => [ Glove Compartment, Installing ] See: 

7

Screws

 3.5 Nm

‹› Qty. 2

‹› Tightening sequence, refer to => [ Glove Compartment, Installing ] See: 

8

Bolt -