A3 Quattro V6-3.2L (CBRA) (2009)
If indication jumps to approx. -40.0° C:
-
End diagnosis and switch ignition off.
-
Replace the Engine Coolant Temperature (ECT) Sensor ( G62).
If indication remains at approx. 140.0° C:
Checking wiring
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) ( J220).
-
Using a multimeter, check the Engine Coolant Temperature (ECT) Sensor ( G62) electrical harness connector terminals to the Motronic Engine
Control Module (ECM) (J220) electrical harness connector T121 terminals for an open circuit according to the wiring diagram.
Specified value: 1.5 ohms Max.