A3 Quattro V6-3.2L (CBRA) (2009)
/Page-512009.png)
-
If necessary, turn camshafts at hex head surfaces - arrows - to correct position using open end wrench SW 32.
CAUTION!
Risk of damaging valves and piston crowns.
‹› If camshafts are rotated, crankshaft may not rest with any piston at " TDC".
‹› Both camshaft adjusters (identification: 24E on intake side and 32A on exhaust side) can only be bolted in one position on the camshaft mountings
- arrows - by an alignment pin.
-
First install intake side camshaft adjuster:
