A3 Quattro V6-3.2L (CBRA) (2009)
-
Connect Bowden cable for temperature door onto base plate - A - (only present on vehicles without A/C system).
-
Connect base plate - D - to Heater Control Module (J65) (A/C Control Module (J301 )) - C - => [ Heater and A/C System Controls ] See: Heater
and A/C System Controls.
-
Bring rotary switch - D - into the position in which the flexible shaft - C - can be inserted into mount of base plate - A -.
-
Insert flexible shaft - C - into base plate - A -
-
Bring rotary switch - D - into "air in footwell " position (as shown).
-
Check position of right footwell door - E -, air guide channel - F - must be opened completely.
-
Air guide channel - F - is closed
-
Release flexible shaft - C - from base plate - A -
-
Turn rotary switch - D - into "air distribution to front windshield" position (approximately 180°).
-
Insert flexible shaft - C - into base plate - A -
-
Bring rotary switch - D - into "air in footwell " position (as shown).
-
Check position of right footwell door - E -, air guide channel - F - must be opened completely.
The rest of the installation is performed in the reverse order of removal.