A3 Quattro V6-3.2L (CBRA) (2009)
Alignment: Service and Repair
Front Axle Camber, Centering
Front Axle Camber, Centering
Camber cannot be adjusted.
The camber can only be centered evenly within the tolerance range by sliding the subframe.
-
Depending on the model and engine, remove the lower noise insulation.
-
Remove bolts - 1 - and - 2 - and install new bolts loosely.
-
Slide the subframe - 3 - in the direction of the - arrow - until the camber is even on both sides.
-
Tighten the subframe/bracket bolts - 1 - and - 2 -.
-
Tightening Specifications, refer to => [ Subframe, Diagonal Brace, Stabilizer, Transverse Link, Bracket and Level Control System Sensor
Assembly Overview ] See: Body and Frame/Frame/Subframe/Front Subframe/Service and Repair/Removal and Replacement/Subframe, Diagonal
Brace, Stabilizer, Transverse Link, Bracket and Level Control System Sensor Assembly Overview.
‹› After sliding subframe and steering gear along with it as well, clearance between universal joint of steering column and cutout of bulkhead must be
checked.
-
Remove securing nuts - arrows - and remove foot well trim.
There must be at least 5 mm of clearance between universal joint - 2 - and cutout in bulkhead.