audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Heater Control Module|Page 141 > < ABS Control Module and Hydraulic Unit, Mark 60|Page 135
Page 1
background image

Control Module HVAC: Description and Operation
Heater Control Module

Heater Control Module

‹› A/C system functions (A/C Control Module (J301)), refer to Vehicle Diagnosis, Testing and Information System VAS 5051 under "Guided Fault

Finding"

‹› Rear Window Defogger (Z1) activation, refer to => [ Heated Rear Window, Activating ] See: Windows and Glass/Heated Glass Element/Testing

and Inspection

‹› Function of air recirculation button and activation of Fresh/Recirculating Air Door Motor (V154) => [ Fresh/Recirculating Air Door Motor,

Checking ] See: Heating and Air Conditioning/Air Door/Air Door Actuator / Motor/Testing and Inspection.

‹› Testing the seat heating (optional equipment), refer to => [ Seat Heater, Activation ] See: Heating and Air Conditioning/Testing and

Inspection/Component Tests and General Diagnostics/Seat Heater, Activation

‹› Activation of Engine Control Module -ECM- (in vehicles with gasoline direct fuel injection engine "FSI" and/or with an engine with

diagram-mapped cooling, refer to => [ Engine Control Module, Activating ] See: Testing and Inspection/Engine Control Module, Activating

‹› Beginning with MY 2010, a Start/Stop System is offered as an option on certain engines. The Heater Control Module (J65) has no affect on the

Start/Stop function on vehicles with only a heater (no "A/C"). If the vehicles has a manual climate control system, then, depending on the setting
on the A/C Control Module ( J301) (for example, the heater is on) the Stop function will prevent the engine from being started again as soon as
there is a request for heating. The (J301) Vehicle Diagnosis, Testing and Information System VAS 5051 under "Guided Fault Finding" does not
limit the Stop function when the cooling mode is on.

‹› There is no additional coolant pump for the Start/Stop System installed on vehicles with Start/Stop System. Depending on the vehicle engine, an

electrical coolant pump may be installed, which is controlled by the engine control module.  Refer to => See: Engine, Cooling and
Exhaust/Cooling System/Water Pump and Vehicle Diagnosis, Testing and Information System VAS 5051 under "Guided Fault Finding".

‹› If the vehicle has a Start/Stop System and a manual climate control system, then install A/C Control Module (J301), part number 8P0 820 047,

starting with index "D".

Heater Control Module|Page 141 > < ABS Control Module and Hydraulic Unit, Mark 60|Page 135