A3 Quattro V6-3.2L (CBRA) (2009)
CAUTION.
DO NOT attempt to remove control module without releasing center retaining clip as described in next step. Damage to control module
will result.
-
Insert drill bit with dia. 2.5 mm (or equivalent tool such as a screwdriver etc.) as illustrated- 2 - approximately 45 mm into hole - arrow 1 - in
order to release center retaining clip - arrow 2 -. It may be necessary to twist the drill/tool slightly in order to release clip.
Only after center retaining clip has been released:
-
Pull module down slightly and remove drill/tool.
-
Release rear retaining clip - arrow - and remove module.
-
Disengage locks on electrical connections and disconnect electrical connections.
Installing
Install in reverse order of removal, noting the following:
-
First engage top steering column trim into forward portion of bottom trim - arrow 1 - as illustrated.