A3 Quattro V6-3.2L (CBRA) (2009)
-
Disconnect electrical connector on crash sensor.
-
Remove bolts - 2 - (Qty. 2).
-
Remove front airbag crash sensor.
Installing
Installation is reverse of removal, but note the following:
CAUTION!
Ignition must be on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired correctly, they may
deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
-
Disconnect the battery ground wire with the ignition switched on.
‹› If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.
2
Screws - 9 Nm
‹› Qty. 2
Front Side Airbag Crash Sensor
CAUTION!
‹› Follow the safety precautions for pyrotechnic components.
‹› Follow the safety precautions for front side airbag crash sensors (pressure sensors). Refer to => [ Front Side Airbag Crash Sensors
Safety Precautions ] See: Service Precautions.
‹› Before handling pyrotechnic components (e.g. connecting the electrical connector), the person handling it must "discharge static
electricity ". This can be done by touching door striker, for example.