A3 Quattro V6-3.2L (CBRA) (2009)
Control Arm: Service and Repair
Transverse Link Bonded Rubber Bushing
Transverse Link Bonded Rubber Bushing
Special tools, testers and auxiliary items required
‹› Thrust Plate (VW 402)
‹› Punch (VW 411)
‹› Tube (T10219/1)
‹› Drift (T10219/2)
Pressing Out Bonded Rubber Bushing
-
Press out bonded rubber bushings as depicted in the illustration.
1 - Punch (VW 411)
2 - Tube (T10219/1)
3 - Thrust Plate (VW 402)
Pressing In Bonded Rubber Bushing
Bonded rubber bushing must be installed at an angle to prevent damaging it when pressing in. Bonded rubber bushing settles straight while pressing
in.
-
Apply installation lubricant on to outside of bonded rubber bushing.
-
Place bonded rubber bushing on at an angle (in direction of transverse link), when doing this the lip - arrow - must slip into hole as shown in the
illustration.