A3 Quattro V6-3.2L (CBRA) (2009)
Front Subframe Mount: Adjustments
Subframe Mount, Adjusting
Special tools, testers and auxiliary items required
‹› Engine Support Bridge (10-222 A)
Adjusting
If an insufficient or an excessive distance is measured, proceed as follows:
-
If equipped, remove vacuum hose - 2 - to air guide hose.
-
Disconnect air guide hose - 1 - at throttle valve control module (J338).
-
Disconnect mass air flow (MAF) sensor (G70) electrical connector - 3 -.
-
Unbolt upper section of air filter housing - arrows -.
-
Remove filter element.
-
Pull off air guide cover - 1 -, disengage clips sideways to do so.
-
Unclip air duct - 2 -.
-
Remove lower section of air filter housing - arrows -.