A3 Quattro V6-3.2L (CBRA) (2009)
6
Cover Plate
7
Nut
‹› 20 Nm plus an additional 90° turn
‹› Self-locking
‹› Always replace after removal
8
Bolt
‹› 12 Nm
‹› M6 x 10
9
Ventilated Brake Disc
10
Bolt
‹› Always replace after removal
When tightening, the vehicle must be on the ground.
‹› Different versions, allocation.
‹› Hex bolt = 200 Nm plus an additional 180° turn, refer to => [ Drive Axle Hex Combination Bolt, Loosening and Tightening ] See:
Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Procedures/Drive Axle Hex
Combination Bolt, Loosening and Tightening.
‹› Twelve point bolt = 70 Nm plus an additional 90° turn, refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See:
Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Procedures/Drive Axle Twelve-Point
Bolt, Loosening and Tightening.
‹› Before installing, clean the threads in the constant velocity joint with a tap.
11
Bolt
‹› 4 Nm
12
Wheel Hub with Wheel Bearing
‹› Sensor ring for ABS is installed in wheel hub
‹› Various versions.
13
Wheel Bearing Housing
14
Bolt
‹› 70 Nm plus an additional 90° turn
‹› Always replace after removal
15
Driveshaft
‹› Do not let the driveshaft hang down when assembling. The inner joint could be damaged if it is bent too far.
16
Hex Nut
‹› Self-locking
‹› Always replace after removal