A3 Quattro V6-3.2L (CBRA) (2009)
Constant Velocity Joint: Service and Repair
Drive Axle, Inserted Inner Joint with Inner Splines
Drive Axle, Inserted Inner Joint with Inner Splines
Removing
-
Remove the noise insulation.
-
Loosen wheel side drive axle threaded connection.
‹› Procedure for loosening the hex combination bolt. Refer to => [ Drive Axle Hex Combination Bolt, Loosening and Tightening ] See: Service and
Repair/Procedures/Drive Axle Hex Combination Bolt, Loosening and Tightening.
‹› Procedure for loosening 12-point bolt. Refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See: Service and
Repair/Procedures/Drive Axle Twelve-Point Bolt, Loosening and Tightening.
-
Remove wheel.
-
Remove hex nuts - arrows - on the ball joint.
-
Remove nut from the level control system sensor linkage.
-
Disengage transverse link from ball joint.
-
Tip suspension strut outward while pressing drive axle out of wheel bearing unit with a brass drive.
‹› Do not let the drive axle hang down. The inner joint could be damaged if it is bent too far.
A second technician is needed for the following steps.
-
Insert assembly fork - 1 - between the transmission housing and triple roller joint.