A3 Quattro V6-3.2L (CBRA) (2009)
6
Bolt
‹› 8 Nm
7
Right Rear ABS Wheel Speed Sensor (G44)/Left Rear ABS Wheel Speed Sensor (G46)
‹› Can be checked in Guided Fault Finding using the
‹› Before inserting sensor, clean inner surface of mounting hole and coat with polycarbamide grease (G 000 650)
8
Wheel Bearing Housing
‹› Different versions: Aluminum and steel
‹› Removing and Installing, refer to => [ Wheel Bearing Housing ] See: Wheel Bearing Housing
9
Bonded Rubber Bushing
‹› Replacement, refer to => [ Wheel Bearing Housing Bonded Rubber Bushing ] See: Wheel Bearing Housing Bonded Rubber Bushing
10
Washer
‹› Installed only on vehicles with aluminum wheel bearing housing
11
Nut
‹› 45 Nm
‹› Always replace after removal
12
Brake Disc
13
Bolt
‹› 4 Nm
14
Dust Cap
‹› Always replace after removal
‹› Pressing off and driving in, refer to => [ Wheel Bearing Unit ] See: Wheel Bearing Unit
An appropriate seal can only be achieved with a new dust cap.
15
Bolt
‹› Always replace after removal
‹› Tightening specification for vehicles with aluminum wheel bearing housings: 200 Nm plus an additional 180° turn. Allocation
‹› Tightening specification for vehicles with steel wheel bearing housings: 180 Nm plus an additional 180° turn.
‹› Clean the threads in the stub axle with a tap before installing.
‹› Loosening and tightening with XZN 18 socket (T10162 ), refer to => [ Drive Axle Hex Combination Bolt, Loosening and Tightening ] See:
Axle Shaft Assembly/Service and Repair/Procedures/Rear Suspension/Drive Axle Hex Combination Bolt, Loosening and Tightening
16
Wheel Hub with Wheel Bearing
‹› Sensor ring for ABS is installed in wheel hub
‹› Removing and installing, refer to => [ Wheel Bearing Unit ] See: Wheel Bearing Unit
The wheel bearing and wheel hub are installed together in a housing.