A3 Quattro V6-3.2L (CBRA) (2009)
‹› Insert the bolt - 8 -.
‹› Tighten the collar shoulder bolts - 3 - by hand.
‹› Lightly press window frame - 1 - inward at top.
‹› Remove the front and rear adjustment bushings - arrow a - (9 mm hex socket).
‹› Insert the bolt - 5 -.
‹› Tighten collared shoulder bolts - 3 - to 32 Nm.
‹› Tighten bolts - 5 - at front and rear to 32 Nm.
‹› Tighten bolt - 8 - to 10 Nm.
‹› Tighten the locating bolt - arrow b - inside the window frame to 32 Nm.
‹› Knock in lower half of door seal into inner door plate.
‹› Secure window regulator rail with bolts - 7 - to inner door plate.
‹› Press threaded pin of window regulator reel through inner door plate until it engages.
2
Rear Door
3
Collared shoulder bolt
‹› 32 Nm
4
Cover
‹› After combination bolts - 5 - have been tightened to tightening specification (32 Nm), press covers into door trim.
5
Combination screw
‹› 32 Nm
‹› Before tightening combination bolts to tightening specification, adjustment bushings must make contact using an Allen wrench (width across
flats 9 mm).
6
Collar screws
‹› 3.5 Nm
7
Collar screws
‹› 6 Nm
8
Bolt
‹› 6 Nm
Window Regulator Motor, Removing