A3 Quattro V6-3.2L (CBRA) (2009)
Windshield Washer Switch: Service and Repair
Windshield Washer System, From 06.2008
Windshield Washer Fluid Level Sensor
Special tools, testers and auxiliary items required
‹› Reservoir
Removing
-
Switch off ignition and remove ignition key.
-
Remove the front section of the front right wheel housing liner
-
Remove fog lamp => [ Fog Lamp, through 05.2008 ] .
-
Place a reservoir under the washer fluid reservoir.
-
Disconnect the electrical connector - 3 -.
-
Remove the windshield washer fluid level sensor ( G33) - item 1 - from the washer fluid reservoir - 4 -.
Installing
Install in reverse order of removal, observing the following:
-
Check the sealing grommet - 2 - for damage.
-
Install fog lamp => [ Fog Lamp, through 05.2008 ] .
-
Install the front section of the front right wheel housing liner