A3 Quattro V6-3.2L (CBRA) (2009)
Windshield Washer Spray Nozzle: Adjustments
Rear Window Spray Nozzle, Adjusting
Rear Window Spray Nozzle, Adjusting
Special tools, testers and auxiliary items required
‹› Windshield washer aiming tool (T10127) fitted with replacement tip (3125/5 A)
Procedure
-
Adjust nozzles using Windshield Washer Aiming Tool (T10127) so that the water jets are sprayed onto the rear window above the wipers at the
points shown.
‹› Dimension - a - = approximately 125 mm.
‹› Dimension - b - = approximately 295 mm.
‹› Dimension - c - = approximately 5 mm.
-
If the spray field does not correspond to the specifications, clean dirty spray jet.
Cleaning the nozzle:
-
Remove nozzle => [ Rear Window Spray Nozzle ] See: Service and Repair/Rear Window Spray Nozzle.
-
Flush nozzle opposite to spray direction using clear water.
-
To remove remaining impurities, the nozzle must only be blown out opposite to spray direction using compressed air.
-
If the spray field still does not correspond to the specifications, replace the spray jet.