A4 V6-3.0L (AVK) (2004)
/Page-5173003.png)
-
Lift retaining springs in succession on both ends using screwdriver and remove gas-filled strut.
Installation
-
Clip in gas-filled strut at bottom first, then at top.
-
Install with tube end of strut at rear lid.
Releasing gas from gas-filled strut
-
Clamp gas-filled strut in vice area x. Dimension of - x - = 50 mm (2 in.).
CAUTION:
-
Clamping must only be done in this area, otherwise there is a risk of an accident.
-
Always wear eye protection when performing this procedure.
-
Cover area of sawn portion with a rag to absorb oil spraying out.
-
Using saw, cut into cylindrical part of strut at point within first third of cylinders length (measured from cover edge at piston rod end of cylinder).
