A4 V6-3.0L (AVK) (2004)
/Page-1489004.png)
^
Position lower part of 3364 valve stem removal tool at valve stem oil seal.
^
Secure 3364 valve stem removal tool using a drift or cotter pin driver -1- as shown in illustration.
^
Position a lever at 3364 valve stem removal tool and remove valve stem oil seal (arrow).
Installing
Note: A plastic sleeve -A- supplements the new valve shaft seals.
^
Place plastic sleeve -A- on valve stem to prevent damage to new valve stem oil seals -B-.
^
Lightly oil sealing lip of valve stem oil seal.
^
Slide valve stem oil seal onto plastic sleeve.
^
Carefully press valve stem oil seal onto valve guide using 3365 valve stem seal driver.
^
Remove plastic sleeve.
^
If the valve keepers were removed from the installation cartridge, they must be inserted into VAS5161/18 insertion device next.
Note: The large diameter of the valve keepers points upward.
^
Press VAS5161 /8 installation cartridge onto insertion device from top and take up valve keepers.
^
Set VAS5161/8 installation cartridge into VAS5161/13 guide sleeve or VAS5161/14.
^
Press down pressure fork and pull knurled bolt upward while turning left and right - the valve keepers are inserted in this manner.
^
Release pressure fork with the knurled bolt still pulled.
^
Insert valve lifters.
^
Install camshafts, Refer to Camshaft, Engine, Service and Repair
Note:
