audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Cabin Air Filter|Locations|Page 12204 > < Fresh Air Blower Control Module (J126) and Fresh Air Blower (V2), Removing and Installing|Page 12200
Page 1
background image

Cabin Air Filter: Locations

A/C System Control And Regulation Components

NOTE:

-

Service work on refrigerant circuit.

-

After completion of repair carry out the following:
-

Check DTC memory

-

Initiate basic setting

-

Erase DTC memory

-

Electrical testing on components marked with a 1).

-

All components marked with a 2) will be activated during the output Diagnostic Test Mode (DTM).

-

The center defroster vent for the front windshield can be replaced without removing the instrument panel.

Components in engine compartment and rear of vehicle

1

-

Sunroof with solar cells
-

Not applicable in USA

2

-

Service connection
-

Low pressure side

-

For measuring, discharging and charging

-

Cap with seal, always re-install after using service valve

3

-

Dust and pollen filter
-

Follow filter change intervals

-

Different versions (with or without active carbon filter element)

4

-

Threaded connection in refrigerant line (with restrictor)
-

Only open the threaded connection when the refrigerant has been discharged from the A/C system.

5

-

Service connection
-

High pressure side

-

For measuring, discharging and charging

-

Cap with seal, always re-install after using service valve

Cabin Air Filter|Locations|Page 12204 > < Fresh Air Blower Control Module (J126) and Fresh Air Blower (V2), Removing and Installing|Page 12200