A4 V6-3.0L (AVK) (2004)
Note:
^
The illustration on the reservoir of the charging device for CVT transmissions VAS 5162 displays a warning indication in the top left corner to use
ONLY the ATF specially formulated for CVT transmissions.
^
The illustration also shows pictures of the steps required to fill the transmission. These steps will be explained in the following.
CAUTION:
^
Do NOT start the engine when there is very little or no ATF left in the transmission following a repair or as a result of a massive loss of ATF.
^
In this case you need to fill the transmission first with 4.5 to 5 liter of ATF.
Requirements for test
-
Transmission not in emergency running mode.
-
Vehicle in horizontal position.
-
Vehicle diagnostic, testing and information system VAS 5051 connected, vehicle self-diagnosis mode activated and vehicle system
2. transmission electronics" selected.
-
Engine idling.
-
Air conditioner and heating must be switched off.
-
At start of test, ATF temperature must not be higher than 30°C ' allow transmission to cool down if necessary.
Note:
^
The ATF level will vary according to the temperature of the ATF.
^
If the ATF level is checked when the ATF temperature is too low, this will result in overfilling.
^
If the ATF level is checked when the ATF temperature is too high, this will result in underfilling.
^
Overfilling or underfilling will impair the function of the transmission.
^
The ATF temperature appears in the display of vehicle diagnostic, testing and information system VAS 5051.