A4 V6-3.0L (AVK) (2004)
-
Check the following wire connections for open circuit according to wiring diagram:
Harness connector
Test box
Terminal
Socket
3
108
4 (signal)
93
-
Specified value: Wire resistance max 1.5 Ohm
-
Also check wires for short circuit to each other as well as to B+ and Ground (GND).
-
Specified value:infinity Ohm (no continuity)
-
If necessary, repair wire connection.
If no malfunctions are found in wires:
-
Replace Engine Control Module (ECM).
Final procedures
After repair work, the following work steps must be performed in the mentioned sequence:
1
-
Check DTC memory, "Mode 3: Check DTC memory". See: Testing and Inspection/Scan Tool Testing and Procedures/Scan Tool Testing/With
Generic Scan Tool/Diagnostic Mode 3: Check DTC Memory
2
-
If necessary, erase DTC memory, "Mode 4: Reset/erase diagnostic data". See: Testing and Inspection/Scan Tool Testing and Procedures/Scan
Tool Testing/With Generic Scan Tool/Diagnostic Mode 4: Check Reset/Erase Diagnostic Data
3
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Audi Drive Cycle/Readiness
Code/With Generic Scan Tool/Readiness Code, Generating
-
End diagnosis and switch ignition off.