A4 V6-3.0L (AVK) (2004)
After repair work, the following work steps must be performed in the mentioned sequence:
1
-
Check DTC memory, "Mode 3: Check DTC memory". See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Scan Tool Testing/With Generic Scan Tool/Diagnostic Mode 3: Check DTC Memory
2
-
If necessary, erase DTC memory, "Mode 4: Reset/erase diagnostic data". See: Computers and Control Systems/Testing and Inspection/Scan
Tool Testing and Procedures/Scan Tool Testing/With Generic Scan Tool/Diagnostic Mode 4: Check Reset/Erase Diagnostic Data
3
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness
Codes/Audi Drive Cycle/Readiness Code/With Generic Scan Tool/Readiness Code, Generating
-
End diagnosis and switch ignition off.