A4 V6-3.0L (AVK) (2004)
Display Group 062
-
Observe readouts in display zones 3 and 4.
-
Slowly depress accelerator pedal.
-
Percentage displayed in zone 3 should rise evenly. Tolerance range from 12 to 97% is not fully utilized.
-
Percentage displayed in zone 4 should also rise evenly. Tolerance range from 4 to 49% is not fully utilized.
NOTE: The value displayed in zone 3 must always be about twice as large as that in zone 4.
-
Exit function "08 - Read measured value block" by pressing <- button.
If the displays are not as described:
-
Check voltage supply and wiring for accelerator position sensor.
If the displays are not as described:
Checking voltage supply for accelerator position sensors
-
Remove driver's storage compartment.
-
Disconnect connector for accelerator position sensors.
-
Switch ignition on.
-
Connect multimeter as follows to measure voltage:
Connector
Specified value
terminal
1 + ground
approx. 5 V
1 + 5
approx. 5 V
2 + ground
approx. 5 V
2 + 3
approx. 5 V