A4 V6-3.0L (AVK) (2004)
3
Battery positive
-
Specified value: approx. 10 V
-
Repair any open/short circuit as necessary.
If the specified values are all achieved and the LED test light does not flash (measured between terminals 1 and 2 with starter connector attached),
-
Install a new CMP sensor
If the specified values are not obtained:
Checking wiring between CMP sensor and engine control module.
-
Connect test box VAG1598/31 to wiring harness for engine control module; do not connect engine control module. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Scan Tool Testing/With Manufacturer's Scan Tool/Scan Tool Connecting and
Initial Checks/Wiring and Component Testing Using VAG1598/31 Test Box
-
Check for open circuit and short to positive or ground in following wiring connections:
-
Camshaft Position (CMP) sensor -G40- (Bank 1)
Connector
Test box VAG 1598/31
terminal
Socket
1 (positive)
98
2 (signal)
87
3 (ground)
108
-
Camshaft Position (CMP) sensor 2 -G163- (Bank 2).
Connector
Test box VAG 1598/31
terminal
Socket
1 (positive)
98
2 (signal)
86
3 (ground)
108
-
Camshaft Position (CMP) sensor 3 -G300- (Bank 1).
Connector
Test box VAG 1598/31
terminal
Socket
1 (positive)
98