A4 V6-3.0L (AVK) (2004)
/Page-164002.png)
-
Release harness connector -arrow- and disconnect it from Transmission Control Module (TCM).
-
If present, cut through cable tie.
-
Pull off connectors -2- at rear of connector strip.
-
Unscrew wire connection -1-.
-
Release catches s -arrows- and remove auxiliary relay carrier in E-Box toward top.
-
Detach engine wiring harness at E-box and at bulkhead and move it free.
-
Remove securing nuts -arrows-.
-
Lift E-Box and remove upward.
Installing
Installation is reverse of removal, paying attention to the following:
NOTE: All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.
Tightening torque
E-box plenum chamber to body: 3 Nm
