A4 V6-3.0L (AVK) (2004)
-
Remove Fuel Pump (FP) relay.
-
Connect test box to wiring harness of Engine Control Module (ECM); ECM is not connected. See: Powertrain Management/Computers and
Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Text
Box, Connecting For Wiring Test
-
Check the following wire connection for open circuit according to wiring diagram:
9-pin relay carrier in driver's
Test box
footwell, left side, position 1
Terminal
Socket
5
65
-
Specified value: Wire resistance max 1.5 Ohm
-
Also check the wire for short circuit to B+ and Ground (GND).
-
Specified value: infinity Ohm (no continuity)
-
If necessary, repair wire connection.
If no malfunctions are detected:
-
Replace Fuel Pump (FP) Relay -J17-.
or
-
Replace Engine Control Module (ECM).
Check voltage supply for Fuel Pump (FP) and components
-
Remove fuses S228, S232, and S234 (positions 28, 32, and 34) from fuse holder.
-
Connect multimeter for voltage measurement to Ground (GND) and to one terminal of the following fuses in the fuse holder.
-
Operate starter briefly.
Fuse
Specified value at one of the terminals
S228
approx. battery voltage
S232
approx. battery voltage
S234
approx. battery voltage
If specified values are not obtained:
-
Repeat test at another terminal of fuse socket.
If specified values are not obtained again:
-
Check wire connections for open circuit according to wiring diagram: