A4 V6-3.0L (AVK) (2004)
2 (signal)
81
3 (Ground -GND-)
108
-
Camshaft Position (CMP) Sensor 4 -G301- (bank 2)
Harness connector
Test box
Terminal
Socket
1 (B+)
98
2 (signal)
54
3 (Ground -GND-)
108
-
Specified value: Wire resistance max 1.5 Ohm
-
Also check wires for short circuit to each other as well as to B+ and Ground (GND).
-
Specified value: infinity Ohm (no continuity)
-
If necessary, repair wire connection.
Final procedures
After repair work, the following work steps must be performed in the mentioned sequence:
1
-
Check DTC memory, "Mode 3: Check DTC memory". See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Scan Tool Testing/With Generic Scan Tool/Diagnostic Mode 3: Check DTC Memory
2
-
If necessary, erase DTC memory, "Mode 4: Reset/erase diagnostic data". See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Scan Tool Testing/With Generic Scan Tool/Diagnostic Mode 4: Check
Reset/Erase Diagnostic Data
3
-
Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Scan Tool Testing/With Generic Scan Tool/Diagnostic Mode 4: Check Reset/Erase Diagnostic Data
-
End diagnosis and switch ignition off.