A4 V6-3.0L (AVK) (2004)
-
Disconnect harness connector at Clutch Pedal Position (CPP) switch -1-.
-
Connect multimeter between terminal 2 and 3 for resistance measurement.
-
Specified value: approx. 0 Ohm
-
Depress clutch pedal.
-
Specified value:infinity Ohm (no continuity)
If specified value is not obtained:
-
Replace Clutch Pedal Position (CPP) switch.
If specified values are obtained:
Checking voltage supply
-
Connect e.g. V.A.G 1527 B voltage tester as follows:
Harness connector
Measure to
Terminal
3
Chassis Ground (GND)
-
Switch ignition on.
-
LED must light up.
-
Switch ignition off.
If LED does not light up: