A4 V6-3.0L (AVK) (2004)
-
Connect multimeter between terminals 2 and 3 to measure resistance.
-
Specified value: 730 to 1000 Ohm
NOTE: The resistance value of the engine speed sensor is associated with a temperature of 20 degree C. The resistance increases if the temperature
increases.
If specified value is not attained:
-
Install a new engine speed sensor.
If specified value is attained:
-
Connect multimeter between terminals 2 and 1 (screen) and 3 and 1 (screen) to measure resistance.
-
Specified value: each case infinite Ohms (no continuity).
If specified value is not attained:
-
Install a new engine speed sensor.
If specified value is attained:
-
Connect test box VAG1598/31 to wiring harness for engine control module; do not connect engine control module. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Scan Tool Testing/With Manufacturer's
Scan Tool/Scan Tool Connecting and Initial Checks/Wiring and Component Testing Using VAG1598/31 Test Box
-
Check for open circuit and short to positive or ground in following wiring connections:
Connector
Test box VAG 1598/31
terminal
Socket