A4 V6-3.0L (AVK) (2004)
Fuel Level Sensor: Service and Repair
Fuel Level Sensor 2 -G169-, Removing And Installing
Special tools and equipment
-
Wrench for fuel tank sender unit 3087
-
To remove Fuel gauge sender II, the fuel tank must not be more than 1/4 full. Empty fuel tank if necessary.
WARNING: Observe safety precautions when disconnecting the battery.
-
With ignition switched off disconnect battery ground strap.
-
Open fuel filler cap briefly, then close it again.
-
Remove rear seat bench.
-
Detach cover for flange (left side) -arrows-.
-
Carefully disengage and remove electrical harness connector (arrow) (left side of vehicle).
WARNING: The fuel system is under pressure. Before opening the system, place a cloth around the connection. Then release pressure by carefully
loosening the connection.